Trusted Blown-In Insulation for Las Vegas Homeowners
If your upstairs bedrooms hit 88°F by 3 p.m. while the hallway thermostat reads 74°F, the problem is usually not your air conditioner. It’s the insulation in your attic, and in Las Vegas it has likely been baking and settling since the home was built. Blown-in insulation is the fastest way to refill an attic floor to a proper depth, seal the gaps that let desert heat pour in, and cut the run time on your AC during July and August. Our technicians have up to 15 years of experience working Las Vegas attics, and most blown-in jobs are completed in a single visit. Call (844) 560-6351 and a live person answers day or night.

What Our Blown-In Insulation Service Includes
Blown-in insulation is loose material machine-blown into an attic floor, wall cavity or crawl space at a measured density. It fills around trusses, plumbing chases and recessed light boxes that batts can’t wrap. Every job we run in Las Vegas starts with a depth check and an air-sealing pass so the new material actually performs.
Blown-In Cellulose
Cellulose is recycled paper fiber treated with fire retardant, blown wet or dry to a dense, settled blanket. It’s the right choice when you want good thermal performance in an attic floor and a material that fills odd framing shapes without gaps. We install GreenFiber cellulose in Las Vegas homes to bring attic floors up to current R-value targets, and we meter the bags so the depth on your receipt matches the depth in your attic. It’s a strong fit for older homes in Winchester and Sunrise Manor where framing spacing isn’t uniform.
Blown-In Fiberglass
Fiberglass loose-fill is spun glass fiber blown to a set thickness, and it’s the standard choice for ventilated attics in southern Nevada because it doesn’t hold moisture and won’t feed mold. You need it when your existing attic insulation has compacted and lost R-value, which happens faster here than in cooler climates. We use Owens Corning and Johns Manville fiberglass, tune the blower for the density your attic needs, and install baffles at the eaves so the new material doesn’t block the soffit vents that keep your roof deck cool.
Dense-Pack Wall Insulation
Dense-pack is fiberglass or cellulose blown into closed wall cavities through small drilled holes, packed tight enough to resist settling over time. Knob-and-tube era homes in Paradise and older stretches of Las Vegas often have no wall insulation at all, and this is the least invasive way to fix it without tearing out drywall. We patch and texture the injection holes afterward, and we check each cavity with a pressure gauge so we know it’s actually full rather than hollow at the top.
Blown-In Top-Up
A top-up adds new loose-fill on top of existing insulation that has settled below code depth, which is the most common situation we find in Las Vegas attics. It’s the sensible move when your current material is still clean and dry but sitting at R-11 or R-19 when it should be much higher. We remove any contaminated or pest-damaged areas first, then blow the new material to a consistent depth with depth markers stapled at multiple points so you can verify the result yourself. If the old insulation is soiled or full of rodent debris, we pair the top-up with insulation removal and replacement instead of covering it over.
Brands We Service for Blown-In Insulation
We work with the insulation industry’s benchmark material lines, and familiarity with each one matters more than it sounds. Owens Corning fiberglass behaves differently in the blower than Johns Manville, and setting the machine wrong wastes material and leaves you with a thin spot over the hottest part of the attic. We’ve run both in Las Vegas attics enough to know how each wants to be fed. The same goes for Knauf loose-fill, which we install in wall cavities where a tighter packed density is what stops settling.
Cellulose is its own craft. GreenFiber cellulose needs the right moisture level when blown wet, and too dry a mix means it never binds the way it should. Our crews adjust for that on every job. Whether your attic calls for fiberglass, cellulose or a mix of both, we can help you choose the right material for your home’s construction, roof type and budget, and we’ll tell you plainly which one we’d put in our own attic.
Signs You Need Blown-In Insulation Right Now
- Upstairs rooms run 5 to 10 degrees hotter than downstairs. That temperature split is the classic sign of a thin or settled attic floor. Las Vegas attics can reach 150°F on a summer afternoon, and heat pushes straight down through under-insulated ceiling drywall.
- Your attic insulation sits below the top of the floor joists. Put on a respirator, take a flashlight, and look. If the fluffy material is below the joist line in most of the attic, you’re under-insulated and losing cooled air every hour the AC runs.
- Your cooling bills jumped this summer compared to last. A jump of $60 to $100 a month on the same usage pattern usually points to insulation that has compacted. Blown-in fiberglass in Las Vegas tends to lose depth over a decade of extreme heat cycling.
- You found rodent droppings, chewed vapor barrier or soiled insulation. Don’t blow new material over that. It needs to come out first, and we handle attic cleaning and rodent proofing alongside the insulation work so it doesn’t happen again.
- Drafts along exterior walls in January. Cold winter mornings around Las Vegas drop fast once the sun sets, and a drafty exterior wall usually means an empty wall cavity. Dense-pack fills it without tearing out your drywall.
Our Blown-In Insulation Process – Step by Step
- 1
Attic inspection and depth measurement. We climb into the attic, measure existing insulation depth with a ruler at several points, check for moisture staining, and note where air sealing is missing. You get a written read on what’s actually there, not a guess.
- 2
Air sealing before we blow anything. We foam the top plates, wire penetrations, plumbing chases and recessed light frames. Blown-in insulation can’t do its job if warm attic air is still leaking through the ceiling plane.
- 3
Baffles and prep. We install rafter baffles at the eaves to keep soffit vents clear, protect exhaust fans and can lights, and lay down drop cloths so the material stays in the attic and off your floors.
- 4
Blowing to a measured depth. We run the blower to reach your home’s target R-value, then check depth with markers at multiple points across the attic. If it’s short somewhere, we add more before we leave.
- 5
Final walkthrough. We walk you through what went in, show you the depth, and leave you with the paperwork. Everything we do is covered by our 90-Day Done Right Promise, so if the work isn’t right, we make it right.
How Much Does Blown-In Insulation Cost in Las Vegas?
A typical blown-in attic top-up in Las Vegas runs $1,200 to $2,800 depending on square footage, existing depth and how much air sealing is needed. A full removal and replacement in an attic with soiled or pest-contaminated material runs $2,500 to $5,500. Dense-pack wall insulation for a standard single-story home runs $1,500 to $3,200 based on the number of wall cavities and how many injection holes it takes.
| Service | Typical Las Vegas Range | What Drives the Price |
|---|---|---|
| Attic top-up (blown-in fiberglass or cellulose) | $1,200 – $2,800 | Square footage, target R-value, how much existing material stays |
| Full removal and replacement | $2,500 – $5,500 | Contamination, rodent damage, attic access difficulty |
| Dense-pack wall insulation | $1,500 – $3,200 | Number of cavities, drywall patching, multi-story homes |
| Air sealing add-on | $400 – $900 | Number of penetrations, attic geometry, accessibility |
What moves the price most in this market is attic access. Homes in Summerlin and Spring Valley often have tight scuttle doors and low-clearance roof lines that take longer to work in. Patching and texturing after wall injection also adds cost. To avoid overpaying, get an itemized written quote that separates material, air sealing and any removal work; a flat number with no breakdown is where surprises live. Our estimates are free and upfront, no-hassle pricing, and standing discounts apply: $50 Off Any Repair Over $250, an $89 Seasonal Tune-Up, and a permanent 5% Senior & Veteran discount.

Blown-In Insulation Near Las Vegas – Our Service Area
We work attics across the Las Vegas valley, from Winchester and North Las Vegas down through Paradise and Henderson, and out to Boulder City and Sandy Valley. Most jobs get scheduled quickly and finished in a single visit. If you’re in Summerlin or Spring Valley, we’re usually in your neighborhood that week. Our blown-in insulation in Las Vegas page covers the full scope of what we install.
Serving Las Vegas, NV – Our Local Coverage Area
We serve Las Vegas and nearby communities. Use the map below to see the area we cover. If you’re nearby, we can almost certainly help.
Frequently Asked Questions – Blown-In Insulation in Las Vegas
Blown-in insulation is loose fiberglass or cellulose that’s machine-blown into an attic floor or wall cavity to a measured depth. It forms a continuous blanket that fills around trusses, pipes and wiring that batts can’t wrap. In a Las Vegas attic, it’s the most practical way to reach proper R-value without ripping out existing material.
Most attic top-ups take 3 to 5 hours for a standard single-story home, including air sealing. Full removal and replacement can run a full day or into a second visit if the attic is heavily contaminated. We’ll give you a realistic window when we quote the job.
Attic top-ups run $1,200 to $2,800, full replacement runs $2,500 to $5,500, and dense-pack wall work runs $1,500 to $3,200 for most homes. Call (844) 560-6351 for an exact quote, and estimates are free.
Yes. We install Owens Corning, Johns Manville and Knauf fiberglass loose-fill, along with GreenFiber cellulose. We’ll recommend the material that fits your attic’s construction and ventilation rather than defaulting to one brand for every home.
Often yes. Our phones are answered by a live person 24/7, so call any hour and we’ll tell you the soonest available slot. Same-day work depends on attic access and how far into the valley you are, but we do get same-day top-ups scheduled regularly.
Every job is covered by our 90-Day Done Right Promise. If the depth isn’t what we quoted or the work isn’t right, we come back and make it right. We’re licensed and insured, and every technician sent to your home is background-checked and uniformed.
Clear the attic access point and move any breakables away from it. If you’re having wall insulation done, pull pictures off the walls in the rooms we’ll be working in. Otherwise, just leave us a clear path and we handle the rest, including cleanup.
Schedule Your Blown-In Insulation Service in Las Vegas Today
Stop losing money through your attic. Call (844) 560-6351 and a live person will answer, day or night, to set up a free, no-obligation estimate. Our technicians bring up to 15 years of experience, most jobs finish in a single visit, and every job is backed by our 90-Day Done Right Promise. Blown-in insulation is one of ten services we run under one roof, so you’re not juggling contractors for the sealing and repair work that goes with it.
Written by the team at Warmline Insulation Co.